BenQ MP512 - Page 93

93
2. RS-232 Command Code
CMD ACTION
A
SCII
(DDP2000)
condition
Power
Power On <CR>*pow=on#<CR> Execute under Standby
Power off <CR>*pow=off#<CR> Execute under power on
Power Status <CR>*pow=?#<CR>
Source Selection
(depend on models)
VGA/YPbPr <CR>*sour=RGB#<CR>
Execute under power on
VGA/YPbPr-2 <CR>*sour=RGB2#<CR>
YPbPr <CR>*sour=YPbr#<CR>
DVI-A <CR>*sour=dviA#<CR>
DVI-D <CR>*sour=dvid#<CR>
HDMI <CR>*sour=hdmi#<CR>
HDMI-2 <CR>*sour=hdmi2#<CR>
Network <CR>*sour=net#<CR>
Composite <CR>*sour=vid#<CR>
SVIDEO <CR>*sour=svid#<CR>
Current source <CR>*sour=?#<CR>
Audio
Mute On <CR>*mute=on#<CR>
1.power on
2. System will execute after Audio
commanding, but audio related
OSD will refresh until turn-off
and reopen OSD
Mute Off <CR>*mute=off#<CR>
Mute Status <CR>*mute=?#<CR>
Volume + <CR>*vol=+#<CR>
Volume - <CR>*vol=-#<CR>
Volume <CR>*vol=?#<CR>
Picture Setting
(depend on models)
Contrast + <CR>*con=+#<CR>
1. Execute under power on and
connecting to source
2. System will execute after
commanding, but
bright ,contrast,& aspect related
OSD will refresh until turn-off
and reopen OSD
3.Unable to execute under freeze
on or blank on status
Contrast - <CR>*con=-#<CR>
Contrast value <CR>*con=?#<CR>
Brightness + <CR>*bri=+#<CR>
Brightness - <CR>*bri=-#<CR>
Brightness value <CR>*bri=?#<CR>
Aspect 4:3 <CR>*asp=4:3#<CR>
Aspect 16:9 <CR>*asp=16:9#<CR>
Aspect Auto <CR>*asp=AUTO#<CR>
Aspect Real <CR>*asp=REAL#<CR>
Aspect Letterbox <CR>*asp=LBOX#<CR>
Aspect Wide <CR>*asp=WIDE#<CR>
Aspect
Anamorphic
<CR>*asp=ANAM#<CR>