BenQ MP512 - Page 94

94
Lamp Control
Lamp 1 Hour <CR>*ltim=?#<CR>
Lamp 2 Hour <CR>*ltim2=?#<CR>
Normal mode <CR>*lampm=lnor#<CR>
1. Execute under power on
2. System will execute after
commanding, but Lamp related
OSD will refresh until turn-off
and reopen OSD
Economic mode <CR>* lampm =eco#<CR>
Dual Brightest
<CR>*lampm
=dualbr#<CR>
Dual Reliable
<CR>* lampm
=dualre#<CR>
Single Alternative <CR>* lampm =single#<CR>
LampMode Status <CR>*lampm=?#<CR>
Miscellaneous
Blank On <CR>*blank=on#<CR>
1. Execute under power on and
connecting to source
2. Same as operating Remote, but
cmd divides to ON and OFF
Blank Off <CR>*blank=off#<CR>
Blank Status <CR>*blank=?#<CR>
Freeze On <CR>*freeze=on#<CR>
Freeze Off <CR>*freeze=off#<CR>
Freeze Status <CR>*freeze=?#<CR>
Menu On <CR>*menu#<CR>
1. Execute under power on
2. Same as operating Remote
Up <CR>*up#<CR>
Down <CR>*down#<CR>
Right <CR>*right#<CR>
Left <CR>*left#<CR>
enter <CR>*enter#<CR>
Auto <CR>*auto#<CR>
Zoom In <CR>*zoomI#<CR>
Zoom out <CR>*zoomO#<CR>