BenQ MX726 - Keystone Correction

Operation 27
Correcting 2D Keystone
2D Keystone function enables a wider projector installation area compared to
conventional projectors with limited positioning in front of the screen.
To correct this, you will need to manually correct it following one of these steps.
• Using the projector or remote control
Press / on the projector or remote
control to display the 2D Keystone page. Press ▲/▼ to adjust
vertical values from -30 to 30. Press ◄/► to adjust horizontal
values from -30 to 30.
•Using the OSD menu
1. Press MENU/EXIT and then press ◄/► until
the
Display menu is highlighted.
2. Press ▼ to highlight 2D Keystone and press
MODE/ENTER. The 2D Keystone page
displays.
3. Press ▲, ▼, ◄, ► to adjust the keystone
values.
•Using the QUICK INSTALL key
1. Press QUICK INSTALL on the remote control.
2. Press ▼ to highlight 2D Keystone and press
MODE/ENTER. The 2D Keystone page
displays.
3. Press ▲, ▼, ◄, ► to adjust the keystone
values.
Downloaded From projector-manual.com BenQ Manuals