32 Menu operation
Network (MX825ST/MW826ST)
Settings
Reset Display
Returns all of the adjustments you’ve made for the Display menu to the factory
preset values.
Wired LAN See BenQ Network Projector Operation Guide.
AMX Device
Discovery
When this function is On, the projector can be detected by AMX controller.
MAC Address
(Wired)
Displays the mac address for this projector.
Projector
Installation
The projector can be installed on a ceiling or behind a screen, or with one or more
mirrors. See Choosing a location on page 12.
Remote
Receiver
Allows you to enable all the remote receivers or one specific remote receiver on
the projector.
Auto Source
Search
Allows the projector to automatically search for a signal.
Auto Signal
Adjustment
• On: Allows the projector to automatically determines the best picture timings for
the displayed image when PC signal (analog RGB) is selected and AUTO is
pressed.
• Off: The projector will not respond when AUTO is pressed.
Lamp Settings
• Lamp Mode: See Setting the Lamp Mode on page 37.
• Reset Lamp Timer: See Resetting the lamp timer on page 40.
• Lamp Timer: Displays the number of hours the lamp has been used.
To Next Page
Loading...
