BenQ MX808ST - Page 34

34 Menu operation
System
Baud Rate
Selects a baud rate that is identical with your computer’s so that you can connect
the projector using a suitable RS-232 cable and update or download the projector’s
firmware. This function is intended for qualified service personnel.
HDMI
Equalizer
Adjusts the equalizer gain settings for an HDMI signal. The higher the setting, the
stronger the gain value. If there are more than one HDMI port on the projector,
select the HDMI port first before adjusting the value.
PointWrite
To u c h U n i t
Disables or enables "Type A connector" 5V power output for PointWrite Touch
Module. This function is only available when a PC signal (analog RGB or HDMI) is
selected
Reset Settings
Returns all of the adjustments you’ve made for the Settings menu to the factory
preset values.
Language Sets the language for the On-Screen Display (OSD) menus.
Standby
Settings
• Network (MX825ST/MW826ST): Allows you to make following settings:
• Monitor Out: Allows the projector to output a VGA signal when it is in standby
mode and the PC 1 jack and the MONITOR OUT jack are correctly connected
to devices.
• Audio Pass Through (MW809ST/MX825ST/MW826ST): The projector
can play sound when it is in standby mode and the corresponding jacks are
correctly connected to devices. Press / to choose the source that you wish to
use. See Connection on page 17 for how to make the connection.
Background
Settings
• Background: Sets the background color for the projector.
• Splash Screen: Allows you to select which logo screen will be displayed during
projector start-up.
Menu Settings
• Menu Type: Switches to the Basic OSD menu.
• Menu Display Time: Sets the length of time the OSD will remain active after
your last key press.
Audio
Settings
(MW809ST/
MX825ST/
MW826ST)
• Mute: Temporarily turns off the sound.
• Volume: Adjusts the sound level.
• Power On/Off Ring Tone: Turns on or off the ring tone when the projector is
in startup and shutdown process.
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
Enable Network
Standby Mode
Allows the projector to provide the network function in
standby mode.
Switch to Normal
Standby Mode
Allows the projector to disable the network function
after a set period of time after it enters standby mode.
For instance, if 20 min is selected, the projector is able to
provide the network function for 20 minutes after it
enters standby mode. When 20 minutes is up, the
projector enters normal standby mode.