Name: BenQ PD3200Q
Brand: BenQ
Rating: 5 (1 reviews)

To Next Page

To Previous Page

22 How to assemble your monitor hardware

Rotating the monitor

1. Pivot the display.

Before rotating the monitor with a portrait viewing orientation, the display has to be rotated 90

degrees.

Click to launch the Display Pilot Software (downloaded from www.BenQ.com), and check

Auto Pivot to set the display to rotate with the monitor automatically.

Alternatively, right-click the desktop and select Screen resolution from the popup menu. Select

Portrait in Orientation, and apply the setting.

Depending on the operating system on your PC, different procedures should be followed to adjust the screen

orientation. Refer to the help document of your operating system for details.

2. Fully extend the monitor and tilt it.

Gently lift the display up and extend it to the maximum

extended position. Then tilt the monitor.

The monitor should be vertically extended to allow to rotate

from landscape to portrait mode.

3. Rotate the monitor 90 degrees clockwise as

illustrated.

To avoid the edge of the LCD display hitting the monitor base

surface while it is being rotated, do tilt and extend the monitor

to the highest position before you start to rotate the display. You

should also make sure there are no obstacles around the monitor

and there is enough room for cables. Remove the connected USB

peripherals and audio cable first.

Other manuals for BenQ PD3200Q

Questions and Answers:

Need help?

Do you have a question about the BenQ PD3200Q and is the answer not in the manual?

General