Basic operations22
Basic operations
Turning the display on or off
1. Be sure to follow the instruction of Connecting power on page 21.
2. Before turning on the display, make sure the Power switch is set to ON. The system
will enter standby mode.
Operations in the OSD menu
The display’s standby mode still consumes power. To completely cut off power supply, set the
Power switch to OFF (O) and then disconnect the power cord from the power outlet.
Using the remote control
1. Press MENU to open the OSD menu.
2. Press and to select a feature and press or to adjust settings. Press
OK to confirm changes.
3. Press
EXIT to close the OSD menu.
To Next Page
Loading...
