BenQ SH960 - Operating in a High Altitude Environment

40
Using the projector
English
The info page displays the information and status of this projector.
For more information, visit http://www.crestron.com & www.crestron.com/getroomview.
Operating in a high altitude environment
We recommend that you activate High Altitude Mode when your environment is higher than 1500 meters
(around 4920 feet) above sea level, or whenever the projector will be used for extended periods of time
(>10 hours) without shutdown.
To activate High Altitude Mode:
1. Press MENU/EXIT and then press / until the Advanced Setup
menu is highlighted.
2. Press to highlight High Altitude Mode.
3. Press / to select On. A confirmation message is displayed.
4. Highlight Ye s and press ENTER.
Operation under High Altitude Mode may cause a higher decibel
operating noise level because of increased fan speed necessary to improve
overall system cooling and performance.
If you use this projector under other extreme conditions excluding the
above, it may display auto shut-down symptoms, which is designed to
protect your projector from over-heating. In cases like this, you should
switch to High Altitude Mode to solve these symptoms. However, this is
not to state that this projector can operate under any and all harsh or
extreme conditions.
Press Exit to go
back to the
remote network
operation page.
High Altitude Mode is used when
the environment is higher than 1500m.
Do you want to turn the
High Altitude Mode on?
Yes
No
WARNING
Lamp Settings
Baud Rate
High Altitude Mode
Password
Reset All Settings
Advanced Setup
EXIT Back
S-Video
On
Expert Mode
115200
HDMI Settings
Test Pattern
Audio Settings
Lan Control Settings
Signal Power On Off