Network connection20
Network connection
Connecting to a LAN
To set the display to connect to a local area network:
1. Connect a RJ45 cable to the corresponding ports on the display and your LAN
switch or router.
2. Enter the OSD menu Setup > Ethernet Setting.
3. Enter the next OSD menu Setting > Network Settings.
If you are in a DHCP environment, select DHCP and press OK.
If you are not in a DHCP environment, select Static and press OK. Contact your
network administrator for information on the IP Address, Subnet Mask,
Default Gateway, Primary DNS settings and enter it accordingly.
4. To save the settings and return to the previous menu, press MENU on the remote
control.
Controlling the display
Make sure the Setting > Control Setting menu is set to LAN if you would like to turn on the display
with LAN control.
You cannot control the display via the RS-232C connector when LAN control is in use.
To Next Page
Loading...
Need help?
General
