Operation 61
The Information menu shows you the current operating status of the projector.
5. System Setup: Advanced menu
Network
settings
Wired LAN
See
"Controlling the projector through a Wired LAN environment" on
page 44
for details.
AMX Device Discovery
When AMX Device Discovery is On, the projector can be
detected by AMX controller.
MAC Address
Displays the MAC address for this projector.
Reset All
Settings
Returns all settings to the factory preset values.
The following settings will still remain: Position, Phase, H. Size,
Projector Installation, Language, High Altitude Mode, Security
Settings, Baud Rate.
6. Information menu
Current
System Status
Source
Shows the current signal source.
Picture Mode
Shows the selected mode in the Picture menu.
Lamp Mode
Shows the current lamp mode.
Resolution
Shows the native resolution of the input signal.
3D Format
Shows the current 3D mode.
Color System
Shows input system format, NTSC, PAL, SECAM or RGB.
Lamp Usage Time
Displays the number of hours the lamp has been used.
Firmware Version
Displays the firmware version of the projector.
FUNCTION DESCRIPTION
To Next Page
