Need help?Do you have a question about the BENSON CP4 and is the answer not in the manual?
General| Brand | BENSON |
|---|---|
| Model | CP4 |
| Category | Controller |
| Language | English |
Displays initial screen states upon receipt and calibration needs.
Allows end-user programming of settings after initial setup.
Procedure for setting the desired heating temperature and frost protection.
Guides setting up daily ON/OFF switching periods for the heater.
Setting the current day and date for accurate operation.
Turning the heater OFF and activating standby mode.
Temporarily overriding programmed settings for short periods.
Managing heater faults, including remote reset.
Definitions of optimisation, preheat, rate of change, and override.
How to operate and return to the normal RUN mode.
Explains ON/OFF and High/Low mode screens and target display.
Steps to set an ON/OFF override for a specific duration.
Activating standby mode for night setback temperatures.
How to view the current time and date.
Managing heater faults, including remote reset.
Sending a reset signal when no lockout indication is present.
Using the fan for ventilation in summer months.
Entering the program mode requires an engineer's code.
Adjusting day and night setback temperatures, and frost protection.
Programming daily switching periods (start/end times).
Setting and copying daily ON/OFF switching times.
Configuring the current time, date, and day of the week.
Managing user and manager security codes.
Programming dates and durations for periods without heating.
Instructions to cancel a programmed holiday.
Setting override limits, optimisation, and pre-heat.
Setting the time for building temperature rise per degree.
Configuring fan modes, sensors, and control types.
Setting up pre-purge and post-purge times.
Enabling double ignition for condensation-prone areas.
Configuring the system with or without a proving switch.
Activating high flame boost for faster heating.
Configuring the differential for two-stage heating.
Enabling double ignition for condensation-prone areas.
Configuring the system with or without a proving switch.
Selecting user, constant, or summer fan modes.
Enabling and calibrating internal or remote sensors.
Setting up service intervals and contact information.
Managing warning displays for service intervals.
Restoring all settings to factory defaults.
Details on enclosure, dimensions, relays, supply, sensors, battery, and fuses.
Wiring diagram for connecting remote sensors.
Wiring for optional proving and override switches.
Diagram showing input terminals for sensors and switches.
To Next Page