18
To call up the error log press key shift (11) followed
by key prog (8). This can be done at anytime without
interrupting the programme.
Display (12) shows „E“ (stands for „Error“) followed by
the error #. You can read out about the last 50 errors.
The kind of display, the apperance, the options to call
up the values etc. are absolutely identical as described
before for the data log.
The error log records in seqence all previous errors.
The log can only be purged by the manufacturer and
is very efficient and essential to track up problems in
kiln or controller.
If the error log is empty the display reads „- -“ (see
display shown on the left hand side). This applies to
an empty data log as well.
Calling up the
Error Log
Note
The error that happened last (and so the most current
error) has the lowest number and is shown first
To Next Page
Loading...
Need help?
General
