Beretta POWER PLUS 50 M User Manual

POWER PLUS
WALL-HUNG
CONDENSING
BOILER
MURALE
À CONDENSATION
INSTALLATION INSTRUCTION
NOTICE INSTALLATEUR

Beretta POWER PLUS 50 M Specifications

General

Model	POWER PLUS 50 M
Brand	Beretta
Heat output	50 kW
Type	Boiler
Fuel Type	Natural Gas

Summary

General Safety Devices

Safety Devices

Wiring Diagrams

Control Panels

Setting the User Parameters

Installer Programming Mode

Test Mode

Error Mode

Reset Faults

Installing the Boiler

Cleaning the System

Fuel Connections

Flue Gas Outlet and Combustion Air Intake

Preparing the Condensate Drain

Electrical Connections

Terminal Block Inside the Master Control Panel

Filling and Emptying the Systems

Filling

Emptying

Preparing for First Start-up

Starting for the First Time

Checks During and After First Start-up

Checking the Gas Supply Pressure

Checking Combustion

Setting the Functional Parameters

Setting the Central Heating Parameters

Setting the Domestic Hot Water Parameters

Setting the Temperature Controller

Emergency Function

Managing Heating Demand via Analogue Input

Analogue Input for Heat Output

Safety Functions on the Slave Boards

Setting the Addresses for Cascading Configurations

Setting the ADDRESSES

Procedure for configuring slave generator addresses for master recognition.

Errors Codes

Errors on the Master Board

Description of error codes occurring on the Master board.

Errors on the Slave Board

List of slave errors requiring manual reset or automatic deactivation.

List of Slave Errors: Automatic Reset

List of Parameters

USER Parameters

Installer Parameters

Parameters accessible via password for installer-level configuration.

Conversion from One Type of Gas to the Other

Adjustments

CO2 Adjustment at Maximum Output

Procedure for adjusting CO2 levels for maximum burner output.

CO2 Adjustment at Minimum Output

Procedure for adjusting CO2 levels for minimum burner output.

Checking the Calibration

Shutting Down for Extended Periods

Servicing

Cleaning the Boiler and Dismantling the Inside Components

Instructions for cleaning the boiler's exterior and interior components.

Removing the Front Panel, Accessing the Control Panel and the Inside of the Boiler

Dismantling the Master and Slave Boards

Dismantling the Fan

Dismantling and Cleaning the Burner and the Exchanger

Cleaning the Drain Trap and Condensate Drain

Troubleshooting