Bernette Straight Stitch B08 - Wide Edgestitching; Sewing Hem Edges; Sewing a Narrow Hem

SEWING
32
2024-06 EN 5020105.00A.04
> Tighten the screw.
3.9 Wide Edgestitching
> Fit the seam guide and adjust the desired distance to the needle.
> Set the required stitch length.
> Guide the fabric edge along the seam guide.
3.10 Sewing hem edges
> Set the required stitch length.
> Attach the Straight Stitch Foot or the Narrow Straight Stitch Foot.
> Guide the inner, upper hem edge on the right along the edge of the presser foot.
3.11 Sewing a Narrow Hem
The hemmer foot (optional accessory) is required.
> Fit the hemmer foot.
> Set the required stitch length.
> Fold the edge of the fabric by approx. 3mm and fold it over again. Fold the first 5cm of the fabric edge
to be sewn over.
> Place the fabric edge with the wrong side of the fabric facing upwards under the presser foot, slightly
less than the width of the presser foot.
> Sew 4–5 stitches.
> Raise the needle and presser foot.
> Pull the fabric backwards by about 10–15cm. Do not cut the thread.
> Hold the 4 threads in your left hand. Pull the edge of the fabric into the spiral guide on the hemmer foot
using your right hand.
> Lower the presser foot.