Bernette Straight Stitch B08 - Sewing Basting Stitches; Gathering

SEWING
33
2024-06 EN 5020105.00A.04
> Continue sewing slowly while slightly folding the cut edge of the fabric in front of the hemmer foot and
holding it to the left. Guide the edge of the fabric evenly into the spiral guide on the hemmer foot and
sew.
3.12 Sewing Basting Stitches
The basting stitch is suitable for basting several layers of fabric. When sewing basting stitches, it is
recommended to use a fine darning thread. The darning thread is easier to remove.
> Fit the straight stitch foot.
> Set the maximum stitch length.
Pin the fabric layers at a right angle to basting direction to prevent the layers from slipping.
3.13 Gathering
Ideal for fine and medium-weight fabrics. To decorate clothes or decorative items.
> Fit the straight stitch foot.
> Set the stitch length to «4».
> Set the thread tension to «2» or less.
> Pull out the upper and bobbin threads by approx. 5in (20cm).
> Sew along the fabric edge at the width of the foot. Sew with a few reverse stitches at the beginning.
Leave the thread ends about 4–5in (10–12cm) long when finished.
> Sew an additional line at a distance of approx. 1/4in (5mm). Sew with a few reverse stitches at the
beginning. Leave the thread ends about 4–5in (10–12cm) long when finished.
> Pull the bobbin threads and spread the little pleats evenly.