Position the fabric so that the needle is 2mm
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
When lowering the presser foot, do not push in
the front of the presser foot, otherwise the
darning will not be sewn with the correct size.
Please Note:
Pass the upper thread down through the
hole in the presser foot. Pull down the
buttonhole lever .
The buttonhole lever is positioned behind
the bracket on the buttonhole foot. Gently
hold the end of the upper thread in your left
hand, and then start sewing.
If the sewing range is too big to sew, then we
suggest you can sew several times (or cross
sew) to get better sewing result.
Darning stitches are sewn from the front of
the presser foot to the back, as shown.
Basic Sewing Procedures
To Next Page
Loading...
