22
3. INSTALLATION INSTRUCTIONS
• For the most secure installation, use a stud-finder
to secure the anti-tip brackets in wall studs. If
no studs are present at the correct installation
location, follow the instructions below.
WARNING:
Always make sure that the area to be drilled
into is free of any waterlines or electrical
circuits, which could cause damage, injury,
or death.
• Use a drill to create holes for wall anchors (#2) at
the marked points. (5/16”, Ø8)
• Use a hammer to install the wall anchors (#2) if
no stud is present.
• Install the brackets (#1) in place, using 4 screws
for each.
You must use both (two) brackets to ensure that
the appliance is safely supported.
NOTE:
If you are not confident that the supplied
connectors and anti-tip brackets are
mounted on the wall as securely as they
should be, you can use alternative anti-tip
methods.
If there is a cabinet panel behind the back
wall of the refrigerator, make sure that it is
securely fastened to the wall. For this, you
need to be sure that the back wall of the
cabinet panel is axed to a wall stud.
Thickness
To Next Page
Loading...
