Bertazzoni REF18FCBIPRV - Installation Instructions; Pre-Installation Checks; Mounting Anti-Tip Brackets

21
EN
3. INSTALLATION INSTRUCTIONS
3.1 Before Installation
Proceed with installation of the product according
to the instructions below. Be sure to take into
account national and local code requirements
regarding installations.
Please comply with the following:
• For the USA, The National Electrical Code, ANSI/
NFPA 70 (latest version)/State or Municipal
directives and/or regional directives.
• For Canada, The Canadian Electrical Code, C22.1
(latest version)/State or Municipal directives
and/or regional directives.
3.2 Mounting the Anti-Tip Brackets
WARNING:
If the unit cannot be secured to the
cabinetry (which in turn must be secured to
wall) to prevent tipping, make sure to use
the supplied anti-tip brackets in order to
prevent the appliance from tipping over.
WARNING:
Make sure that there is no electrical or
water connection in the adjacent cabinets
into which the mounting screws will be
screwed to secure the refrigerator.
WARNING:
Please remember to use the necessary
protective equipment when drilling holes in
the wall and performing the installation.
• Use a tape measure to mark the wall for
installation of the anti-tip brackets.
Category
REF18FCBIPRV /
REF18FCBIPLV
REF24FCBIPNV REF24RCBPNV REF30RCBPNV
A 18” (457mm) 24” (609mm) 24” (609mm) 30" (762mm)
B 11 5/8” (295mm) 17 5/8” (447mm) 17 5/8” (447mm) 23 5/8" (600mm)
C 3 3/16" (81mm) 3 3/16" (81mm) 3 3/16" (81mm) 3 3/16" (81mm)
Anti-tip bracket, on the wall