7 / 49
Hoisting and moving of equipment
When carrying out the work involved in transportation, positioning and installation, it is necessary
to carry out fixation, hoisting installation and transportation of equipment under the guidance of
the manufacturer's engineering personnel. Avoid equipment damage and personnel injury due to
improper operation during the process of hoisting.
2.6 Use predetermined spare parts and working parts
Original parts and accessories are specially designed for this equipment. original spare parts and
accessories not supplied by machine manufacturer should not be inspected and approved by the
manufacturer. The installation or use of such products may, in some cases, change the original
characteristics of the equipment in the design and imperil the safety.
Warns
The manufacturer shall not be liable for any loss caused by the use, incorrect installation or
replacement of non- original parts and accessories.
2.7 Fire prevention
Make sure the normal use of portable fire extinguisher
Two portable fire extinguishers mentioned below should be prepared for fire prevention:
➢ The portable fire extinguisher for combustion of metal is used to eliminate the ignition danger
caused by the fall of hot slag during the laser processing process.
➢ CO
2
portable fire extinguisher is used to eliminate the combustion in the compact dust
collector.
2.8 Classification and hazards of laser products
2.8.1 Categories of laser product
The laser is safe under the reasonable and predictable working conditions. The
reasonable and predictable working conditions refer to that the silo door of the laser is
completely closed, the machine housing cover is in good condition, and the safety door
is closed.
For the visible light laser with a wavelength of 400nm to 700nm, avoidance reactions
including blinking can protect eyes. The indicating red light belongs to this kind of laser,
and direct eye contact is strictly prohibited.
To Next Page
Loading...