3 / 49
Chapter2 Safety Rules
This chapter mainly introduces safety warnings for protecting personnel and the machine, and
makes an introduction to signs used in the owner’s manual. The machine is already equipped with
sufficient safety guarantee, yet it is still with certain risk. All the operators are required to carefully
read through and well understand the safety rules.
2.1 Safety overview
➢ Be aware of safety knowledge of fiber lasers and focus on safety precautions.
➢ Be aware of the possible danger.
➢ Operators are required to wear protective clothing and gloves when necessary. The
requirement is mainly applied when taking out the thermal workpiece by using
suitable tools in this situation. It is necessary to wear appropriate laser protective
glasses by principle under the maintenance service operation mode (level-4 laser
device). Wear a dust mask that clings to the face by principle (anti-toxic-particle and
dust-proof mask with filter grade P3) when operating the dust collector.
➢ Responsibilities of operation, maintenance, overhaul, etc. should be clearly defined
to avoid unclear definition of safety issues.
➢ Read the technical literature of the equipment. We recommend that the user should
require for a written confirmation of reading and understanding the technical
literature from the operator each time.
➢ Be aware of the safety knowledge of optical fiber lasers and pay attention to safety
precautions.
➢ Master the necessary safety skills for the machine operation.
2.2 Master the necessary safety skills for the machine operation
Statement: the company is not liable for any losses if the equipment is not used according to
the safety regulations!
Notes: properly use the equipment. Laser cutting of plastics, modification and refitting of
equipment conducted by users and operators voluntarily, and unsafe working methods are strictly
prohibited.
Only authorized, trained and guided personnel can operate, repair and maintain the machine.
Only specially trained professionals can use electrical, pneumatic, hydraulic and laser
equipment.
In addition, following measures must be performed before the operator can work on the
equipment:
To Next Page
Loading...