42 / 49
Chapter8 Installation and acceptance
8.1 Site conditions and requirements
8.1.1 Personnel requirements
➢ Programming operators shall have obtained college degree for CNC or
electromechanics (including vocational school);
➢ Understand general G codes for machine, be proficient in computer operating, and
have certain knowledge about machine industry;
➢ Able to operate office software and AutoCAD on computer. Provide one set of
programming computer for machine.
8.1.2 Electrical requirements
Specifications for electricity consumption of the whole machine (including host machine, laser, water chiller,
dust collector)
No snap of power voltage or sudden power outage is allowed, for it will easily cause damage to the
laser;
It shall be well grounded (grounding resistance less than 4Ω)
To Next Page
Loading...