Beta 350 - Page 20

1
GENERAL INFORMATION
19
GB
while it is in movement and will not cause the TR2 parameter to be reset. The value
of S2 is NOT saved to the permanent memory.
Average speed function A2
This function describes the correct functionality/display of the average speed
associated with TR2 and S2. When selected, the data is displayed as shown in
the fi gure, along with the “A2” function indicator. The data represents the average
speed maintained by the vehicle (expressed in km/h or mph based on the selected
unit of measure), calculated as the ratio between the distance travelled (represented
by TR2) and the time in which the distance has been covered (represented by S2).
If the data to be displayed exceeds the value of 512, the character -- -- -- -- will be
displayed. The value of A2 is NOT saved to the permanent memory.
Maximum Speed Function (MAX)
This function describes the correct functionality/display of the maximum speed fun-
ction. When selected, the data is displayed as shown in the fi gure, along with the
“MAX” function indicator. The parameter identifi es the maximum speed reached by
the vehicle, expressed in km/h or mph based on the selected unit of measure. The
counter associated with this parameter can be reset by holding down the Mode
button (while the MAX function is being displayed) until the value on the screen is
set to 0.0. The MAX parameter can be reset both while the vehicle is stationary, as
well as while it is in movement.