BREAK-IN
The break-in period lasts for about 10 hours of use. During this period,
please observe the following recommendations:
1 For the first 3 hours of use, the engine should only be used at up to 50% of its power. The engine speed should
not exceed 7000 rpm.
2 For the next 7 hours of use, the engine should only be used at up to 75% of its power.
3 Warm the engine up well before using the bike.
4 Avoid travelling at a constant speed: varying the speed makes the components bed in uniformly and in less
time.
CAUTION:
After the first three hours (or two fills of petrol), change the engine oil.
• Always use super unleaded petrol.
• After the first trip off-road, check all the nuts and bolts.
CHECKS AND MAINTENANCE BEFORE AND AFTER USE OFF-ROAD
To avoid unpleasant surprises while operating the vehicle, we recommend that you perform a series of checks and
maintenance jobs both before and after use. In fact, dedicating just a few minutes to these checks and jobs will not
only make riding safer, but can save you time and money. Proceed as follows:
Tyres
Check the pressure, general condition and tread depth.
Spokes
Check that the tension is correct.
Nuts and bolts
Go over all the nuts and bolts.
Chain
Check the tension (clearance 20 mm) and, if necessary, grease it.
Air filter
Clean the filter and soak it in air filter oil.
Note:
Check that you have the vehicle’s identification documents. On cold days, before setting off we advise
that you run the engine, as a minimum, for the time required to reach the correct operating tempera-
ture. Every time the vehicle is used off-road it needs to be cleaned carefully.
RECOMMENDED LUBRICANTS AND LIQUIDS
To Next Page
Loading...
Need help?
General
