off-road.
SPARKPLUG
Keeping the sparkplug in good condition helps to reduce
fuel consumption and keep the engine running opti-
mally.
To check it, just pull off the plug cap and unscrew the
sparkplug.
Check the gap between the electrodes with a feeler
gauge: it should be
0.6-0.7 mm. If it is not within this range, you can adjust
it
by bending the negative electrode. Take care not to dam-
age the central electrode.
Check also that there are no cracks in the insulation or
corroded electrodes. If you find either of these faults, re-
place the sparkplug immediately.
Check the sparkplug at the intervals given in the table on
page 29.
The best way to fit the sparkplug is to screw it in by hand
until it will go no further,
then lock it with a spanner.
Note:
We recommend that you always use NGK CR7EB
sparkplugs.
FRONT BRAKE
Checking
To check the state of wear of the front brake, you only
need look at the caliper from the front, which gives a
view of the ends of the two brakepads. The pads must
To Next Page
Loading...
Need help?
General
