What to do if the engine is flooded on my Beta RE 125 Motorcycle?
If your Beta Motorcycle's engine is flooded, fully open the gas and keep trying to start the engine for a short while. If it still won’t start, take out the spark plug and dry it.
General| Transmission | 6 speed |
|---|---|
| Seat Height | 920 mm |
| Weight | 122 kg (dry) |
| Fuel Tank Capacity | 11.5 L |
| Rear Suspension | Monoshock with progressive linkage |
| Rear Brake | Single disc, 220 mm |
| Wheelbase | 1, 430 mm |
| Starting System | Electric |
| Clutch | Wet multi-disc |
| Frame | Steel |
| Front Brake | Disc |
Identifies key components of the vehicle.
Details for frame and engine identification codes.
Tyre pressure recommendations for Enduro and Motard.
Identification and function of handlebar controls and switches.
Explanation of display pages, icons, and normal operation.
Describes the order of viewing LCD pages and initial test.
Step-by-step guide for setting the clock on the LCD.
Procedure to hide or show specific display screens.
Explains the meaning and activation of service icons.
Interpretation of battery voltage warning icons.
Controls the vehicle's electrical system and engine start.
Instructions for engaging and disengaging the steering lock.
Key specifications including weight and dimensions.
Fuel tank and engine oil capacities.
Details on the hydraulic fork and oil content.
Information on the rear shock absorber and travel.
Specifications for the front disc brake system.
Specifications for the rear disc brake system.
Details on engine type, bore, stroke, and cooling.
Information on the carburetor and fuel system components.
Table of recommended oils, fluids, and grease.
A visual representation of the vehicle's electrical system.
Details on the battery and its maintenance.
Location and removal of the electronic control unit.
Accessing the flasher unit requires saddle removal.
Location of voltage regulator and HV coil.
Accessing starter contactor and fuse.
Recommended checks before and after operating the vehicle.
Instructions for refueling the vehicle's fuel tank.
Guidelines for the initial 500 km running-in period.
Procedures for electric and kick-start engine ignition.
Important notes and procedure for using the sidestand.
Procedures for checking and changing engine oil.
Checking and topping up front brake fluid.
Steps to remove the seat to access the air filter.
Checking the spark plug condition and gap.
Visual inspection of front brake pad wear.
Visual inspection of rear brake pad wear.
Location and draining of the engine oil fume collection tube.
Procedure for removing the exhaust silencer.
Steps to remove rear and front side panels.
Instructions for removing the fuel tank.
Recommended maintenance intervals and tasks.
Adjusting the rear brake pedal height.
Adjusting the clutch lever's idle stroke.
Setting the engine's idle speed.
Correcting excessive free play in the throttle grip.
Checking and adjusting play in the steering system.
Procedure for checking and adjusting drive chain tension.
Adjusting the rear shock absorber spring preload.
Manual adjustment of the headlight beam vertically.
Step-by-step guide for replacing headlight and position bulbs.
Instructions for replacing the rear tail light bulbs.
Procedures for replacing front and rear turn signal indicators.
Guide to diagnosing and resolving common vehicle problems.
Causes and remedies for engine starting failures.
Potential causes and solutions for engine misfiring.
Identifying and addressing piston knocking issues.
Troubleshooting causes of engine overheating and power loss.
Diagnosing and fixing issues with weak front brake performance.
Diagnosing and fixing issues with weak rear brake performance.
To Next Page
