ENGINE OIL
Use only fully synthetic oils of a reputable brand (BAR-
DAHL XTC60 15W50).
CHECKING THE ENGINE OIL LEVEL
The engine oil level must be checked when the engine
is warm. Run the engine for several minutes and then
switch it off. Place the bike on a flat surface in such a way
that it is perfectly vertical.
Wait a few minutes and then check the oil level in the
sightglass located in the clutch casing (right-hand side of
the engine). The level must be between the limits indi-
cated in the picture.
If necessary, remove the oil filler plug and top up the
level.
N.B. Running the engine with too little oil causes
excessive wear to the engine components.
CHANGING THE ENGINE OIL
N.B. At each oil change, the mesh filters must be
cleaned and the paper filter replaced.
N.B. The oil change must be carried out when the
engine is at working temperature. Be careful not
to scald yourself with the hot oil.
After the engine has reached operating temperature,
switch the bike off and stand it upright.
To Next Page
Loading...
Need help?
General
