EasyManuals Logo

Beta RR 4T 450 User Manual

Beta RR 4T 450
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
3
CHECKS AND MAINTENANCE
56
GB
CHARGING THE BATTERY
Remove the battery and check its charge.
Using an open-circuit multimeter (10-12
hours after the activation), check that the
voltage is greater than 12.6 V. If it is lower,
it is advisable to recharge the battery.
Based on the type of charger available,
charge the battery using either of the fol-
lowing procedures:
Constant voltage (14.4-15 V) - Charge
the battery for about 12 hours. Check
the voltage 10-12 hours after the end of
recharge as described above.
Constant current: Charge battery at
0.5-0.8 A until the voltage between the
terminals stabilizes at ~14.5 V.
WARNING
The battery is sealed. When recharging it,
do not remove the seal nor add any liquid.
WARNING
When recharging, fi rst connect the battery
to the battery charger and then turn on the
charger.
If the battery is charged in a closed room,
take care to ensure proper ventilation as
during the charge the battery produces
explosive gases.

Other manuals for Beta RR 4T 450

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta RR 4T 450 and is the answer not in the manual?

Beta RR 4T 450 Specifications

General IconGeneral
BrandBeta
ModelRR 4T 450
CategoryMotorcycle
LanguageEnglish

Related product manuals