27
1
GENERAL INFORMATION
CONOSCENZA DEL VEICOLO
7. START-UP (AVVIAMENTO DEL
SISTEMA)
All'accensione della strumentazio-
ne il sistema visualizza per l'utente
una serie di informazioni che, per
semplicità vengono rappresentate
su schermate (pagine) successive:
● I
^
pagina (ad ogni collegamento
con la batteria veicolo): Versione
e data di rilascio del software (per
circa 3 secondi) (fi g. 15).
● II
^
pagina (solo alla prima connes-
sione dello strumento o dopo ogni
cancellazione della memoria):
Scelta del modello.
● III
^
pagina (ad ogni accensione
dello strumento): Check di tutti i
segmenti dell'lcd per circa 3 sec.
(fi g. 16).
● IV
^
pagina (ad ogni accensione
dello strumento): Visualizzazione dei
parametri impostati (fi g. 17).
Se l'alimentazione proviene dal
veicolo, durante queste schermate
il sistema esegue il check delle spie
e della retroilluminazione: vengo-
no attivati tutti i led delle spie che
vengono poi spenti al termine del
check del display.
Terminato quanto sopra, il sistema si
porta nella visualizzazione normale.
7. START-UP (SYSTEM START-UP)
When the instrument is switched
on, the system displays a range of
information for the user which, to
make things easier, is represented
on the following screens (pages):
● 1
st
page (at every connection with
vehicle battery): Software version
and date of issuing (for approx. 3
seconds) (fi g. 15).
● 2
nd
page (only at the fi rst con-
nection of the instrument or after
memory erasure): Model selection.
● 3
rd
page (every time the instrument
is switched on): Check of all Icd
segments for approx. 3 seconds
(fi g. 16).
● 4
th
page (every time the instru-
ment is switched on): Display of set
parameters (fi g. 17).
If the power comes from the vehicle,
during these screens the system
carries out a check of all indicator
lights and backlighting: all LEDs are
switched on and then are switched
off at the end of the display check.
Once the above is fi nished, the
system passes to normal display.
Revisione software
Settimana e Anno
rilascio sw
Fig. 15
Fig. 16