03
4.Binding the Receiver
There are the steps to make the LiteRadio 3 enter binding status.
1. Power on the radio transmitterand wait for its system to load completely. LED
ring will be solid blue if done correctly.
2. Press the bind button on the back of the radio transmitter to enter binding stutas.
The LED ring will be red and ash quickly.
3. The LED ring will change to solid blue 5 seconds later when radio transmitter exits
binding status. If not bind successfully, repeat theprocessabove.
5.Switching Protocol
Note: Switching internal protocol is only available for Frsky version radio transmitter.
ExpressLRS version can only switch to the external TX module.
The Frsky version could suppo 4 dierent internal protocols, including Frsky D16
FCC, Frsky D16 LBT, Frsky D8 and Futaba S-FHSS, it also suppos. The protocol is
indicated by the ashing times of the LED when power on, before the buzzer
alarms.
Reason
Solution
Red light solid on
The throttle joystick or
switches are not in the lowest
Lower throttle and switches
to the lowest position.
Turn to blue then.
Red light ashing quickly
Blue light ashing slowly
Red light breathes slowly
Green light breathes slowly
The radio transmitter
is binding
Batte reaches the low
voltage limit
On charging
Charge complete
Charge the transmitter
Wait for completing binding
State of the LED Ring
The buzzer will alarm three times, which indicates a low batte and needs to be re-
charged.
To Next Page
Loading...
Need help?
General
