BETAFPV LiteRadio 3 User Manual

04
LiteRadio 3 radio transmitter has a built-in 2000mAh batte. It indicates low batte
and needs to be re-charged if blue light ashes slowly and buzzer beeps
continuously. Below charging method for reference:
● The LED ring breathes in red means charging, while in green means fully charged.
● Turn o the radio transmitter.
● Plug in radio transmitter with adapter by USB cable (5V output adapter is
allowed).
6.Charging
Note: LiteRadio 3 Frsky version only work with D16 ACCST 1.X Frsky protocol. So if you use a Frsky
receiver with D16 ACCST 2.X version or ACCESS version, binding will fail.
3. Then the ash color and times of the LED before buzzer alarms will change,
according to the tables above.
1. Power the radio transmitter o;
2. Press and hold the BIND button while power the radio transmitter back on;
To change protocols and TX module, here are the steps:
Red Flash once
Internal Frsky D16 FCC (ACCST 1.X Version)
LED Status
Protocol Version
Red Flash twice
Internal Frsky D16 LBT (ACCST 1.X Version)
Red Flash Three Times Internal Frsky D8
Red Flash Four Times Internal Futaba S-FHSS
Purple Flash Three Times Quickly
Internal TX Module O and Run External TX Module
Frsky Version
Red Flash once Internal ELRS
LED Status
Protocol Version
Purple Flash Three Times Quickly
Internal TX Module O and Run External TX Module
ExpressLRS Version

BETAFPV LiteRadio 3 Specifications

General

Frequency Range	2.4GHz
Screen	No
Voice Support	No
Support USB Simulator	Yes
Firmware Upgrade Method	Via USB
RF Power	100mW
Display	No
Protocol	Frsky
Compatibility	Frsky, Futaba
Gimbal Type	Hall sensor gimbals
USB Port	USB Type-C
Channels	8 Channels
Battery	Built-in 2000mAh 1S Battery