Better BT-1 - Sleep, Density, and Timeout Settings; Printing Test Page

BT-1 user manual
Page 48 of 70
ESC 8 n1 n2
[Name]
Sleep parameter
[Format]
ASCII:
ESC 8 n1 n2
Decimal:
27
56 n1 n2
38 n1 n2
Hexadecimal:
1B
[Descrip
tion]
Setting the time for control board to enter sleep mode.
n1+n2*256 The time waiting for sleep after printing finished, Unit
(Second), Default: 0 (don’t sleep).
When control board is in sleep mode, host must send one byte (0xff) to
wak
e up control board. And waiting 50ms, then send printing command
and data.
[Note]
The command is useful when the system is powered by battery.
DC2 # n
[Name]
Set printing density
[Format]
ASCII:
DC2 # n
Decimal:
18 35 n
12 23 n
Hexadecimal:
[Description
]
D4..D0 of n is used to set the printing density
Density is 50% + 5% * n(D4-D0)
D7..D5 of n is used to set the printing break time
Break time is n(D7-D5)*250us
DC2 T
[Name]
Printing test page
[Format]
ASCII:
DC2 T
Decimal:
18
12
84
54
Hexadecimal:
Printing the test page
[Description]
FS t n (for CB105B)
[Name]
Select Timeout
[Format]
ASCII:
FS
t
n
Decimal:
28
116 n
Hexadecimal:
1C
74
n
[Description]
Set Timeout for one byte, t= n×10 ms; so if There are 100 bytes needed
for a command, the printer will wait 1000×n ms, when n=0, the printer will
wait until all chars needed have received.
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com