Better BT-1 - 8.2 Command Details; 8.2.1 Print Commands

BT-1 user manual
Page 14 of 70
GS V
Select cut mode and cut paper (For cut)
ESC p m
ESC c 5
GS ( F
FS C
FS S
FS s
Generate pulse (For drawer)
Enable/disable panel buttons (For button)
Set adjustment values(s) (For 701BM)
Start receive buffer count (For cb65c)
Send receive buffer count(For cb65c)
save print parameter (for XBLY)
FS d
Load default leaving factory set (for XBLY)
8.2 Command Detail
8.2.1 Print Commands
LF
[Name]
Print and line feed
[Format]
ASCII:
LF
Decimal:
10
Hexadecimal:
0A
[Description]
Prints the data in the print buffer
and feeds one line, based on the current
line spacing.
[Note]
This command sets the print position to the beginning of the line.
[Reference]
ESC 2
,
ESC 3
CR
[Name]
Print and carriage return
[Format]
ASCII:
CR
Decimal:
13
Hexadecimal:
0D
[Description]
[Notes]
When automatic line feed is enabled, this command functions the same
as
LF
; when automatic line feed is disabled, this command is ignored.
λ
This command line feed is ignored with a serial interface model.
Sets the print starting position to the beginning of the line.
λ
[Reference]
LF
HT
[Name]
Horizontal tab
ASCII:
[Format]
HT
Decimal:
9
Hexadecimal:
09
[Description]
[Notes]
Moves the print position to the next horizontal tab position.
λ This command is ignored unless the next horizontal tab position has
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com