Better BT-1 - Page 15

BT-1 user manual
Page 15 of 70
been set.
λ
If the next horizontal tab position exceeds the printing area, the
printer sets the printing position to [printing area width+1].
Horizontal tab positions are set with ESC D.
λ
λ
If this command is received when the printing position is at [printing
area width+1], the printer executes print buffer-full printing of the
current line and horizontal tab processing from the beginning of the
next line.
[Reference]
ESC D
FF
[Name]
Print the data in buffer and locate to the next black mark
[Format]
ASCII:
FF
Decimal:
12
0c
Hexadecimal:
[Description]
[Note]
λ
λ
Print the data in the buffer.
Locate to the black mark.
Only board with black mark function support this command.
ESC D n1...nk NUL
[Name]
Set horizontal tab positions
[Format]
ASCII:
ESC D n1...nk NUL
Decimal:
27 68 n1…nk 00
1B 44 n1…nk 00
Hexadecimal:
1≤n≤255
[Range]
0≤k≤32
[Description]
Set horizonta
l tab positions.
λ
n specifies the column number for setting a horizontal tab position
from the beginning of the line.
λ
λ
k indicates the total number of horizontal tab positions to be set.
The horizontal tab position is stored as a value of [character width×n]
measured from the beginning of the line. The character width
includes the right-side character spacing, and double-width
characters are set with twice the width of normal characters.
This command cancels the previous horizontal tab settings.
When setting n = 8, the print position is moved to column 9 by
sending HT.
[Note]
λ
λ
λ
Up to 32 tab positions (k=32) can be set. Data exceeding 32 tab
positions is processed as normal data.
λ
λ
Transmit [n]k in ascending order and place a NUL code 0 at the end.
When [n]k is less than or equal to the preceding value [n]k-1, tab
setting is finished and the following data is processed as normal
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com