Better BT-1 - 8.2.9 New Commands; Mark Paper Feeding; BM Sensor Settings

BT-1 user manual
Page 49 of 70
8.2.9 New commands
DC2 E
[Name]
Feed paper to mark
[Format]
ASCII:
DC2 E
Decimal:
18 69
12 45
Hexadecimal:
[Description]
Feed paper to the Mark position
DC2 m
d 1l 1h
[Name]
Set mark paper length
[Format]
ASCII:
DC2 m d 1l 1h
Decimal:
18 109 d 1l 1h
12 6d d 1l 1h
Hexadecimal:
d = 0,1
[Description]
1:stop at mark position
0:go on 3 steps after mark position detected
0 ≤ ll ≤ 255
0 ≤ lh ≤ 255
Paper length is (ll+l
h*256) steps, means (ll+lh*256)/8 mm
ESC C n (for BM)
[Name]
Set BM Max
[Format]
ASCII:
ESC
C
n
Decimal:
27
67
43
n
n
Hexadecimal:
1B
[Description]
With the current row spacing of unit, the line number to define the scope
of testing black mark, the default value is 4 inches.
GS FF (for BM)
[Name]
Feed marked paper to print starting position
[Format]
ASCII:
GS FF
Decimal:
29
12
Hexadecimal:
1D
0C
[Description]
[Note]
Feeds the marked paper to the print starting position.
Locate to the black mark.
λ
This command sets the next print position to the beginning of the
line.
λ
Even if this command is executed at the print starting position of the
marked paper, the printer does not feed the marked paper to the next
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com