Better BT-1 - Paper Cutting Modes

BT-1 user manual
Page 50 of 70
print starting position.
GS ( F
[Reference]
ESC i (for cut)
[Name]
full cut paper
ASCII:
[Format]
ESC
i
Decimal:
27
105
69
Hexadecimal:
1B
[Description]
ESC i select a paper cutting mode and then full cut the paper.
ESC m (for cut)
[Name]
partial cut paper
[Format]
ASCII:
ESC
i
Decimal:
27
105
69
Hexadecimal:
1B
[Description]
ESC m selects a paper cutting mode and then partial cut the paper.
①
GS V m
②
GS V m n(for cut)
[Name]
Select cut mode and cut paper
[Format]
①
ASCII:
GS V m
Decimal:
29 86 m
1D 56 m
Hexadecimal:
②ASCII:
GS V
29 86
1D 56
m
n
n
Decimal:
m
m
Hexadecimal:
① m=1, 49
② m=66, 0≤n≤255
n
[Range]
[Description]
Selects a mode for cutting paper and executes paper cutting. The value
of m selects the mode as follows:
m
Print mode
1, 49
Partial cut (one po
int left uncut)
Feeds paper (cutting position + [n
×
0.125 mm]), and cuts the paper
partially (one point left uncut).
66
[Notes for
①
and
②
]
λ
λ
Cutting status is different, depending on the installed autocutter type.
This command is effective only when processed at the beginning of a
line.
[Note for
①
] Only the partial cut is available; there is no full cut.
[Notes for
②
]
λ
When n=0, the printer feeds the paper to the cutting position and
cuts it.
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com