Better BT-1 - Page 16

BT-1 user manual
Page 16 of 70
data.
λ
λ
ESC D NUL
cancels all horizontal tab positions.
The previously specified horizontal tab positions do not change,
even if the character width changes.
λ
The character width is memorized for each standard mode.
[Default]
The default tab positions are at intervals of 8 characters (columns 9, 17,
25...) for Font A (12×24).
[Reference]
HT
ESC J n
[Name]
Print and feed paper
[Format]
ASCII:
ESC J n
Deci
mal:
27
74 n
4A n
Hexadecimal:
0≤n≤255
1B
[Range]
[Description]
Prints the data in the print buffer and feeds the paper [n×0.125 mm
(0.0049”)].
[Notes]
λ
λ
λ
After printing is completed, this command sets the print starting
position to the beginning of the line.
The paper feed amount set by this command does not affect the
values set by ESC 2 or ESC 3.
In standard mode, the printer uses the vertical motion unit (y).
ESC d n
[Name]
Print and feed n lines
ASCII:
[Format]
ESC d
n
Decimal:
27
100 n
64 n
Hexadecimal:
0≤n≤255
1B
[Range]
[Description]
[Notes]
Print the data in the buffer and feed paper n lines.
λ
λ
λ
This command sets the print starting position to the beginning of the
line.
This command does not affect the line spacing set by
ESC 2
or
ESC
3.
The maximum paper feed amount is 1016 mm (40 inches). If the
paper feed amount (n×line spacing) of more than 1016 mm (40
inches) is specified, the printer feeds the paper only 1016 mm (40
inches).
[Reference]
ESC 2
,
ESC 3
利用 pdfFactory Pro 测试版本创建的PDF文档 www.pdffactory.com