Beurer MP 70 - Cleaning and Maintenance

20
• Repeat the process of submerging and pulling out six
to seven times, until several layers of paran wax have
formed over the treatment areas. If the paran wax is
either too hot or too cold for you during the treatment
period, turn the temperature controller clockwise or
anti-clockwise, to increase or decrease the temperature
as required.
6-7 x
• Now put a sheet on the treated area, press it onto the
paran wax and twist the end shut. Keep the sheet on
for 20 minutes.
 WARNING
If you are wearing the plastic sleevers on your feet, do not
run around in them. You could slip.
• After 20 minutes, take the sheet and the layers of wax
o the treated area. Dispose the sheet in the general
waste; it cannot be reused.
• After each use, take the protective grille out of the paran bath.
7. CLEANING AND MAINTENANCE
 CAUTION
If the device is only being used by one person, change the paran wax at regular intervals and
clean the paran bath whilst doing so.
If the device is being used by several people, the paran wax should be changed before each
treatment for reasons of hygiene.
• Pull the mains plug out of the socket.
• Take the protective grille out of the paran bath.
• Allow the paran wax to solidify overnight.
 WARNING
Do not use any sharp or pointed objects to remove the wax
block from the paran bath. You could damage or scratch
the paran bath.
• If the paran wax has solidified, press on one end of
the wax block and lift it out of the paran bath. If the
wax block cannot be removed easily, turn the tem-
perature controller to “warm” for ten minutes. Then
remove the mains plug and take the wax block out of
the paran bath.