Beurer MP 70 - Accessories and Replacement Parts; What If There Are Problems?

21
• Then wipe the inside of the paran bath dry with a clean towel.
 CAUTION
Never fill the paran bath with water in order to clean it.
• After cleaning, store the paran bath in a cool, dry and dust-proof place.
8. ACCESSORIES AND REPLACEMENT PARTS
To purchase accessories and replacement parts, please visit www.beurer.com or contact the
corresponding service address (according to the service address list) in your country. Accesso-
ries and replacement parts are also available from retailers.
Designation Item and/or order number
2 x 450 g of paraffin wax + 30 plastic sleevers 589.43
9. WHAT IF THERE ARE PROBLEMS?
Problem Possible cause Solution
The device is not
working
For repairs, please contact Customer
Services or an authorised retailer
Heating lamp/
operation lamp
does not light up
No power supply
Plug the mains adapter into the plug
socket
The mains adapter is faulty. Contact
Customer Services or your retailer.
LEDs have reached the end of
their service life. LEDs faulty
For repairs, please contact Customer
Services or an authorised retailer
Hard wax in par-
affin bath
The oil in the paraffin wax is
used up
Renew the paraffin wax. Only use genui-
ne Beurer paraffin wax
May occur due to frequent
use
A paraffin wax with a higher
melting point is used
Discoloured par-
affin wax
May occur due to frequent
use
Renew the paraffin wax. Only use genui-
ne Beurer paraffin wax
The paraffin wax
takes longer to
melt than usual
The paraffin wax is too cold Store paraffin wax at room temperature
The device is not working
For repairs, please contact Customer
Services or an authorised retailer.