Beurer MP 70 - Signs and Symbols

16
• If the paran wax permanently feels too hot or too cold against your skin, this may be a
physical problem. If this is the case, consult your doctor.
• Make sure that the device is always filled with paran wax up to the MIN fill indicator line
during use.
• Do not apply the paran wax to the treatment area for longer than 20 minutes.
• Do not shake or move the device during use. You could sustain scald or burn injuries.
• If there is hot paran wax in the paran bath, do not pour in any water.
• If pain, irritation, dermatitis or discomfort occurs, terminate the treatment and consult your
doctor.
• Should the device accidentally fall into water, disconnect the mains plug immediately. Have
the device checked by a qualified electrician before it is used again.
 CAUTION
• Switch o the device after use by removing the mains plug from the socket.
• Never remove the mains plug from the socket by pulling on the cable or with damp hands.
• Do not use any sharp or pointed objects to remove the wax block from the paran bath.
You could damage or scratch the paran bath.
• If you are not going to use the device for an extended period of time, store it in a cool, dry
and dust-proof place.
• If you should have any questions about using our devices, please contact either your retai-
ler or Customer Services.
INTENDED USE
This device is intended exclusively for use on the hands, feet or elbows of humans. Do not use
the device on animals!
2. SIGNS AND SYMBOLS
The following symbols are used on the device, in these instructions for use, on the packaging
and on the type plate for the device:
Read the instructions
 WARNING
Indicates a potentially imminent danger. If it is not avoided, there is a risk of death
or serious injury.
CAUTION
Indicates a potentially imminent danger. If it is not avoided, slight or minor injuries
may result.
NOTE
Indicates a potentially harmful situation. If it is not avoided, the system or
something in its vicinity may be damaged.
CE labelling
This product satisfies the requirements of the applicable European and national
directives.
Manufacturer
Disposal in accordance with the Waste Electrical and Electronic Equipment EC
Directive – WEEE