12 BC610 Installation and User manual
Set password
The first thing to do before starting to programme the card
reader is to set a password.
1
Open the card reader with the key supplied. The lock is
located on the underside of the card reader.
2
Press the SW1 button (see wiring diagram on page 8).
3
Enter the desired 6-digit password on the card reader’s
keypad.
The password is now set.
Set the card reader to programming mode
To program a function, the card reader has to be in
programming mode. Proceed as follows:
1
Press B.
!!#
2
Enter the 6-digit password.
###
The card reader is now in programming mode.
Note!
If the wrong password is entered two times in
succession, the card reader is blocked from further attempts
for 10 seconds. From then on the card reader is blocked for 40
seconds each time two incorrect passwords are entered.
To Next Page
