Bewator Bewacard BC610 - Card Logging and Cancellation

BC610 Installation and User manual 13
Log on a card (with a card)
Using this function, the cards to be used are programmed in to
the card reader.
1 Set the card reader to programming mode.
2 Press A01.
!""
3 Swipe the card. If the card is already in the reader, the
”faulty programming” signal is heard.
4 Swipe the next card, as required.
5 When finished, press B to go back to programming
mode.
6 Press B one more time to leave programming mode.
Log on a card (without the card)
Using this function cards can be programmed by keying in the
card number.
1 Set the card reader to programming mode.
2 Press A03.
!""
3 Enter the card number on the keypad. If the card is
already logged on, the ”faulty programming” signal is
heard.
4 Key in the next card, as required.
5 When finished, press B to go back to programming
mode.
6 Press B one more time to leave programming mode.