54
1.8 Connection to a PC
The NE 900 receiver is fitted with an RJ 11 connector with an IN and Out socket.
In order to operate several receivers with a PC they have to be connected as described
below.
• Connect the OUT-socket of the first receiver (RX 1) with the IN-socket of the second
receiver (RX 2), connect the OUT-socket of the second receiver (RX 2) with the IN-socket of
the third receiver (RX 3) and so on.
• Connect the IN-socket of the first receiver (RX 1) to the converter.
• Connect the converter to the USB interface of the PC.
• By using the PC control software, 64 channels can be operated simultaneously at
maximum.
• The distance between PC and receiver should not be too long, because to ensure high-
speed transmission the remote control cable should not be longer than 100 metres.
11
USB PORT
RJ 11
To Next Page
Loading...
