Beyerdynamic QUINTA Series - i Command - Clear Speaking MUs; Chairman Clear Message

41 Conference Control Commands
4.4 a messsage
MU request to speak resp. MU reporting microphone OFF
Communication direction
MU -> CU -> Controller
Same as q message
- MU request to speak resp. MU reporting microphone OFF
- needed for internal reasons
- sent only in PC-controlled mode
4.5 i command
Clear speaking MUs
The i 00 command is used to deactivate all currently speaking MUs or all open
microphones.
This command is also sent when the Chairman presses the Clear button.
Important Note
Please note that in both communication directions, which are shown in the following
two tables, additional protocol lines are received after the i 00 command. These are
shown in the two examples below. Note these when using the system with a media
control.
Communication direction
Controller -> CU -> MU
Syntax
Description
i 00
Clears all speaking MUs resp. all open mics
Note: Does not clear request to speak status
(>> see chapter 4.6: ~Q commands).
>>>> Triggers q and Q messages because the
events following the i 00 command are
microphone OFF and de-allocation.