Beyerdynamic QUINTA Series - System Configuration Commands; F Command - Changing Operation Mode

17 System Configuration Commands
3 System Configuration Commands
3.1 F command
Changing operation mode
The V A command described in the previous section queries whether the CU is in
conference or microphone mode. Of course, the mode can also be changed using a
corresponding protocol command, which is described below.
Important Note
As already mentioned in chapter 2.2, it is necessary to restart the CU to change the
operation mode successfully. This is done using the ^ command, which is also described
in chapter 2.2.
Examples
Communication direction
Controller -> CU
Syntax
Description
F B 2
Select Microphone Mode
F B 1
Select Conference Mode
Select Microphone Mode
Transmit:
F B 2<CR>
Receive:
<CR><LF>
SwMM<CR><LF>
>
Select Conference Mode
Transmit:
F B 1<CR>
Receive:
<CR><LF>
SwCM<CR><LF>
>