Beyerdynamic QUINTA Series - Connectivity and Information Commands; U Commands - Login to Communication Port

7 Connectivity and Information Commands
2 Connectivity and Information Commands
All commands in this chapter are applicable in Conference Mode as well as
Microphone Mode.
2.1 U commands
Login to communication port
Note
The U commands are only sent by the controller to the CU and are not passed on to
other integrated units.
As already stated, in the further course of this document, the direction of
communication is presented in short form as in the first line of the following table.
Communication with the Quinta Control Unit via RS232, USB or Ethernet requires the
external controller to login first. Although the Quinta Control Unit offers three possible
physical ports namely: RS232, USB, Ethernet only one port can be used at a time. Thus
only one external controller can communicate with the Quinta Control Unit at the same
time.
Communication direction
Controller -> CU
Syntax
Description
U 0
Unlock current communication port if no password is set
(factory default)
U 0 pwd
Unlock current communication port with password
U 1 pwd
Set password
Save it permanently in the CU
U 1
Clear password
U B
Lock all communication ports
Parameters
Description
pwd
password
(max. 15 ASCII characters, except: space, <CR>, <LF>)