INITIAL PROGRAMMING
15
MAIN MENU
PARAM
LOGIC TIMER TO CLOSE
RADIO 3 STEP
LANGUAGE IBL OPEN
DEFAULT FAST CLS
AUTOSET PHOTOC. OPEN
TEST PHOT
1 MOT ON
BLOC PERSIST
START-CLOSE
FIXED CODE
RADIO PROG
MASTER
MAIN MENU
PARAM
LOGIC TCA
RADIO 3 STEP
LANGUAGE IBL OPEN
DEFAULT FAST CLS
AUTOSET PHOTOC. OPEN
TEST PHOT
1 MOT ON
BLOC PERSIST
START-CLOSE
FIXED CODE
RADIO PROG
MASTER
MAIN MENU
PARAM TCA
LOGIC M1 T
RADIO M2 T
LANGUAGE M1 T SLOW
DEFAULT M2 T SLOW
AUTOSET OPEN DELAY TIME
CLS DELAY TIME
M1 FAST TIME
M2 FAST TIME
SLOW SPEED
ZONE
AUTOMATIC CLOSING TIMER (TCA)
Enabling the TCA.
1.From the MAIN MENU, select LOGIC.
2.From the LOGIC Sub-menu, select TCA.
3.Switch ON by pressing the + button and then the OK button.
4.Press the + and – buttons at the same time to go back to the MAIN MENU
Adjusting the TCA time. (Default: 10 seconds)
1. From the MAIN MENU select PARAM (Parameters).
2. From the PARAM Sub-menu select TCA.
3. Adjust the amount of seconds by using the + and – buttons.
4. Press OK.
5. Press the + and – at the same time to go back to the MAIN MENU.
IGNORE PHOTO INPUT DURING OPEN CYCLE (PHOTOC. OPEN)
1. From the MAIN MENU select LOGIC.
2. From the LOGIC Sub-menu select PHOTOC. OPEN.
3. Switch ON by pressing the + button and then the OK button.
4. Press the + and – at the same time to go back to the MAIN MENU.
To Next Page
Loading...
