BGates LT - SMS Commands for Relay Control; Activate Pulse Mode via SMS; Activate Bistable Mode via SMS; Deactivate Bistable or Timer Mode

Function SMS Command Notes
23
Device activation in pulse mode
(You can send an sms to activate the relay
instead of calling the device)
password,PULSE,seconds Sets the device to pulse mode and simultaneously
activates the relay for the specied duration (max 60
seconds). The device will send a command conrmation
SMS that can be deactivated with the command E,A0
24
Device activation in bistable mode
(You can send an sms to activate the relay
instead of calling the device)
password,BS,ON Sets the device to bistable mode and simultaneously
activates the relay. The device will send a T1,T8 type
conrmation SMS
25
Bistable or Timer Deactivation (early*)
*to deactivate the Timer feature earlier than the
set time has reached 0
password,BS,OFF Deactivates the relay. The device then stays in Bistable
or Timer mode, depending on the previous setting, and
sends a T2,T9 type conrmation SMS based on the
memorized mode
26
Check Bistable/Timer state password,BS,CHECK Checks the device state, sending a T1,T2,T8,T9,T10 type
SMS in response. In Timer mode, the SMS will contain
the countdown of the remaining minutes.
SMS COMMANDS
As an alternative to calling, you can activate the device relay in the foreseen operating modes (Pulse, Bistable
and Timer) by sending an sms.
21