INSIDE THE BOX
• BGates LT device
• This instruction sheet
TECHNICAL FEATURES
• Power supply 230V - 50/60 Hz.
• The transformer is electronically protected against overloads
and short circuits.
• Absorbed power: 10VA.
• Relay: 230V maximum voltage, maximum current 1A with
resistive load (0.4A inductive load).
• Action Type: 1 B-U.
• Dimensions: 9-unit module for DIN rail.
• Dual mode operation: pulse (default) or bistable.
LOCATION
Install the device in an area where there is a good GSM/GPRS
signal. This area can be identied in the vicinity of the automation
that you want to connect, though its proximity to the gate is not
an essential factor. It is advisable to perform simple eld strength
checks before installing the actuator.
INSTALLATION
The device is equipped with a relay to process the open command.
The device can be installed in an electrical panel or alternatively
in the box tted with DIN rail (EN 50022). Outdoor installations
require the use of a suitable sealed container such as an IP65
weather sealed box.
BGates LT can operate in two modes:
• Pulse (factory default setting): the device closes the relay for
the number of seconds set (factory settings: 2 seconds).
• Bistable: the device closes the relay until the next command.
6
To Next Page
Loading...