Installation
PRECAUTIONS FOR INSTALLATION
• Make sure that the product is intact after removing the
packaging.
• The system must be installed in compliance with current
safety standards.
• An appropriate disconnector and protection switch should be
installed upstream of the actuator.
• Before connecting the device, make sure that the rating plate
data corresponds to that of the distribution network.
• Disconnect the device from the mains power supply before
attempting to clean or service it.
• Disconnect the device and do not touch it in case of failure
and/or malfunction.
• Do not let the device come into direct contact with water
or extreme heat, moisture or heat shock: see the chapter
“installation”.
• Do not obstruct the ventilation or heat dispersion openings or
ns.
• Contact the manufacturer for repairs.
Take note that:
• Failure to comply with the above may compromise the safety
and warranty of the device.
• The manufacturer can not be held responsible for any damage
caused by improper, incorrect and unreasonable use.
5
To Next Page
Loading...