BH ATOM X - Cleaning, Maintenance and Storage; Battery Care; Motor Maintenance; Storage

EN
ATOM USER MANUAL
53
8. CLEANING, MAINTENANCE AND STORAGE
ATTENTION
Do not use high-pressure washers or jet stream cleaners, as they may cause
water ingress, damaging the system, the motor, the display panel or the
battery. If water enters one of these units, ask an authorised dealer to check
your bicycle.
8.1 Battery Care
Keep the battery clean. Use a damp and properly wrung out cloth to clean dirt from the battery case. Do not pour
water directly onto the battery, e.g. with a hose.
ATTENTION
Donotcleanthecontactsbypolishingthemwithaleorusingawire,etc.
Otherwise, it may cause failures.
8.2 Motor Maintenance
Because the motor is a precision machine, do not disassemble it or exert excessive force on it (e.g. do NOT hit
this product with a hammer).
8.3 Storage
Keep the bicycle in a place that is:
• Flat and stable
• Well ventilated and dry
• Protected from the elements and direct sunlight
8.4 Prolonged Storage
If you are going to store the bicycle for a prolonged period (1 month or more), remove the battery and store
it as follows.
• Make sure that the remaining battery capacity is above 50% and then store it indoors, in a cool
(10 to 20°C) and dry place.
• Check the remaining battery capacity once a month, as the battery is slowly discharged while in
storage. If the capacity is below 50%, charge it until it is above 50%.
• When using it again after a prolonged period of storage, be sure to charge the battery before use.
9. TECHNICAL SPECIFICATIONS
9.1 Motor
• Brose DC motor.
• 250 W power. | Maximum assistance speed 25 km/h.
• System voltage: 36 V.
9.2 Battery
• Lithium-ion battery.
• Battery voltage: 36 V.
• Capacity: 500 Wh or 700 Wh (depending on version).
9.3 Central Display Panel
• USB type: USB 2.0.
• Output current: max. 1,000 mA.